HPE 5700 48G 4XG 2QSFP+ Switch

HPE FlexFabric 5700 48G 4XG 2QSFP+ Switch (JG894A)

I/O ports and slots

48 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only

4 fixed 1000/10000 SFP+ ports

2 QSFP+

Additional ports and slots

1 RJ-45 serial console port

1 RJ-45 out-of-band management port

1 USB 2.0

Power supplies

2 power supply slots
1 minimum power supply required (ordered separately)

Fan tray

2 fan tray slots
The customer must order fan trays, as fan trays are not included with the switch. This system requires two same-direction airflow fan trays to function properly.
The system should not be operated with only one fan tray for more than 24 hours. The system should not be operated without a fan tray for more than two minutes.
The system should not be operated outside of the temperature range of 32°F (0°C) to 113°F (45°C). Failure to comply with these operating requirements may void the product warranty.

Physical characteristics

Dimensions

17.32(w) x 18.11(d) x 1.72(h) in (43.99 x 46 x 4.37 cm) (1U height)

Weight

22.05 lb (10 kg) shipping weight

Memory and processor

512 MB flash; Packet buffer size: 9 MB, 2 GB SDRAM

Performance

10 Gbps Latency

< 1.5 µs (64-byte packets)

Throughput

up to 250 Mpps

Routing/Switching capacity

336 Gbps

Routing table size

128 entries (IPv4), 128 entries (IPv6)

MAC address table size

128000 entries

Environment

Operating temperature

32°F to 113°F (0°C to 45°C)

Operating relative humidity

10% to 90%, noncondensing

Acoustic

Low-speed fan: 65.7 dB, High-speed fan: 70.6 dB

Electrical characteristics

Frequency

50/60 Hz

Voltage

100 - 240 VAC, rated

-48 to -60 VDC, rated

(depending on power supply chosen)

Maximum power rating

175 W

Idle power

115 W

Notes

Idle power is the actual power consumption of the device with no ports connected.
Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated.

Safety

UL 60950-1; EN 60825-1 Safety of Laser Products-Part 1; EN 60825-2 Safety of Laser Products-Part 2; IEC 60950-1; CAN/CSA-C22.2 No. 60950-1; Anatel; ULAR; GOST; EN 60950-1/A11; FDA 21 CFR Subchapter J; NOM; ROHS Compliance

Emissions

VCCI Class A; EN 55022 Class A; ICES-003 Class A; ANSI C63.4 2003; AS/NZS CISPR 22 Class A; EN 61000-3-2:2006; EN 61000-3-3:1995 +A1:2001+A2:2005; EMC Directive 2004/108/EC; FCC (CFR 47, Part 15) Class A

Immunity

Generic

ETSI EN 300 386 V1.3.3

EN

EN 55024:1998+ A1:2001 + A2:2003

ESD

EN 61000-4-2; IEC 61000-4-2

Radiated

EN 61000-4-3; IEC 61000-4-3

EFT/Burst

EN 61000-4-4; IEC 61000-4-4

Surge

EN 61000-4-5; IEC 61000-4-5

Conducted

EN 61000-4-6; IEC 61000-4-6

Power frequency magnetic field

IEC 61000-4-8; EN 61000-4-8

Voltage dips and interruptions

EN 61000-4-11; IEC 61000-4-11

Harmonics

EN 61000-3-2, IEC 61000-3-2

Flicker

EN 61000-3-3, IEC 61000-3-3

Management

IMC - Intelligent Management Center; command-line interface; out-of-band management; SNMP Manager; Telnet; FTP

Services

Refer to the Hewlett Packard Enterprise website at http://www.hpe.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local Hewlett Packard Enterprise sales office.